Forum: Third Generation Magna TE - TW

https://i.ibb.co/tDJSVbQ/image.png https://i.ibb.co/m451dJ6/image.png https://i.imgur.com/2N8vWlr.jpg Neighbor backed into my 'very' well maintained KF. Needless to say, not happy. And given the strange colour-changing properties i'm likely to believe it would be impossible for a replacement...

Well maintained 190k dual fuel TW wagon: today it started to occasionally hesitate and surge. It's as tho' I'd taken my foot from the pedal then put it back. Over the last couple of years it's had all new plugs, leads, rotor, cap, timing belt, water pump. Could be lots of things I guess, but...

No sign of the ECU directly under the radio where both the manuals I have say it should be so where is it?

Does anyone know where I can find 18mm rear sway bar Dbush for a Verada Gtvi, which I assume is the same as the VRX. I have found 16mm & 17mm. But no luck with the 18mm.

My stock steering wheel had seen better days and would bend up the top, so i decided to swap it out with a nice fancy 06 mitsubishi 380 leather wheel. I wouldn't reccomend doing this mod due to the fact that you have to cut the existing clockspring wires and do a bit of soldering and heat...

Hi all, I've had the front callipers off (already done the rear), cleaned everything up and replaced the piston seals. However I'm having trouble getting the dust boots into the callipers, in fact I can't get them in. It's a really small gap to get it in and I've already ruined one new one. I've...

Hi all, I bought a KJ Verada AWD today and the drivers seat height goes nowhere as high as the seat height in my KL Verada, I find the KJ's seat height too low when its as high as it will go, is there anyway to get the seat to raise higher? cheers

My TJ's power windows are getting very slow to go up. Has anyone tried silicone spray and if so does it work?

Hi Fellas. I have a 99 TJ 3.5 auto solara sedan with 235000 on the clock that went from using no oil between 10000 K services to using 1 litre every 700 kms almost overnight. The valve stem seals were done around 30000 Ks ago as they were obviously worn, blowing smoke on start up. No oil usage...

Hi, I have just purchased a Magna speedway car and am looking at slowly increasing the performance of the engine, currently run a 6G74 3.5L V6 with 5 speed manual gearbox (locked). The engine is stock from what I can see so far apart from a K&N pod filter, I have a set of extractors to fit on...

Hello all, When I bought my KH XI recently, only the grey valet key was provided. According to the owner handbook there is a serial number for the key to enable it to be replaced by Mitsubishi, which of course I don't have, either. This worries me in case I accidentally lock the boot. What can I...

Hi to all, Well, it's a sad day.:cry: I've decided to part with my trusty TJ.:cry: For 80,000km it has taken me and my family wherever i wanted to go with reliability. But sadly, with over 250k on the clock, i's time. I am happy that she will end up with a family member who will take care of her...

Looking at lowering my Verada, any suggestions on what springs and shocks to use. Was thinking Kings Super low { front } super low or low, not sure which ones at the rear. Will super low at rear be to much at rear? Monroe GT Sport shocks. Or are the better products to use on the Magna/Verada...

Ever since my mechanic replaced the handbrake linings, there's been an annoying low whistling sound from the rear, esp when turning. Slight application of handbrake stops it. I mentioned it to him when he did my radiator work, and he pulled the handbrake drums off and had a look. Said they like...

Today the TW did something it's never done before: the needle went almost to hot. It was a cool 15C day, and the coolant level was fully or nearly so. The car was idling in traffic. It's a v well maintained 190k car. Any suggestions for what I should do next would be much appreciated.

Need to know if anyone knows if they fit over yhem

Hi guys, Just wondering if the 2.4L manual Magna has an intermediary driveshaft like the V6 models or whether it just uses unequal length driveshafts?

Just a general query. I am running a set of the Ralliart Enkei 225/50/17 on a TH Exec. The spare in the tyre well now sits about 30 or 40mm above the boot floor level so I need to adapt the fibreboard cover that sits over it. Also the threaded spare wheel retainer is a little too short to use. I...

Went and bought 12 litres of the Penrite ATF and drained out the old stuff and then flushed through with new until it came out nice and clean. Cleaning up afterwards when I found a bit of wave spring in the tub. :censored: The car is an 01 model so now I'm thinking it's probably better to get a...

Just Purchased a 2005 Mitsubishi Magna TW ES Station wagon 2 weeks ago, it has a set of Pacemakers Extractors on the car, I also have a set of Ralliart Camshafts stamped #7, I will be replacing the timing belt soon and was wondering 1. Is there any difference between the stock Magna V6 3.5L...